Support
ArtiLED normally provides support only to its partners and resellers. If you are an end user and experience a problem, please always contact your reseller first. If you need help with programming, we would first refer you to our Programming Guide. We also offer a number of handy tools that may help you.
We want to make it as easy as possible for programmers to communicate with our lamps and Led Computers. That is why our protocols are completely open. Our Led Computers speak several protocols, all developed in-house. There are three protocols you can use: ArtiAPI, ArtiNET and ArtiTCP. Click the button below for our Programming Guide.
Smart LEDs are usually clocked at 800 kHz. Each LED passes its data on to the next one, so addressing a long addressable LED strip takes time. The longer the strip, the more time it takes and the lower the achievable effect speed. We have developed a handy tool that lets you calculate how many frames per second are still achievable with a given length of LED strip.
Smart LEDs are usually powered from a 5 Volt supply voltage, because every LED is a tiny computer that runs on 5 Volts. Unfortunately, this low supply voltage means that fairly high currents flow through the cabling, so the cable between the power supply and the LED strip cannot be too long. We have developed a handy tool that lets you calculate the required wire thickness for a given length.
Most Smart LEDs are powered from a 5 Volt supply voltage, as mentioned above under the Wire Calculator. Because of this low voltage, a fairly high current flows. It is important to ensure that the connected power supply can deliver sufficient power, and it is always advisable to oversize the power supply to avoid problems with peaks. We have developed a handy tool that lets you calculate which power supply your LED strips require.

